2.5 Installing the backplane and bridge boards

2.5.1 Bridge board (BRIDGE-AR12)

The bridge board links several functions and signals from the motherboard to the backplane board. The board connects to the pair of connectors labeled BPCON on the motherboard and to another pair on the backplane. Four screws secure the bridge board to the motherboard and backplane (indicated by circles in the figure below).

BPCON connectors on the motherboard

Bridge Board (BRIDGE-AR12)

BPCON connectors on the backplane

2.5.2 Bridge board (BRIDGE/S-AR12)

If you installed a RAID card, you may create a RAID configuration using the bundled bridge board for SCSI RAID (BRIDGE/S-AR12).

1.Remove the standard bridge board (BRIDGE-AR12) and replace it with the SCSI RAID bridge board (BRIDGE/S-AR12).

2.Install the bridge board with the 68-pin SCSI connector facing the rear panel (see picture on the next page). Take note of the BPCON connectors for the motherboard (MB) and the backplane (BP).

3.Secure the bridge board with four screws.

4.Connect a 68-pin SCSI cable from the RAID card to the SCSI connector on the bridge board.

24

Chapter 2: Hardware Setup