II. System Components

Hot-Swap Bay

There are two levers on the front of the hot swap tray to help release or lock the tray. To remove the tray, extend both levers and pull on both levers. To install the tray, push the tray firmly into the bay with the levers extended, then close the levers. Three hard disk drive LEDs are located inside the system fan module for each hard disk drive tray. LEDs

provide information on the power and activity status of the hard disk drive. When power is received by the hot-swap tray’s connector board, the power LED will light. When data is written or read to or from the contained hard disk drive, the activity LED will flash proportional to the amount of data transferred.

II. Components

Hot-Swap Tray

Each hot-swap tray provides an aluminum carrier for a single SCSI hard disk drive with a maximum height of 1 inch or 1.6 inch (depending on model), a width of 4 inches, and a length of 6 inches. The aluminum tray provides protection and maximum heat dissipation for almost all types of high speed SCSI disk drives. The provided screws are needed to secure the hard disk drive into the tray.

AP2500 Hardware Reference Guide

23