Rear Panel

1.Digital audio connector

This connector is for a digital signal output cable.

2.Analog audio connector

This connector is for an analog signal output cable.

3.Factory test pins

These pins are used for factory testing.

NOTE: DO NOT cover these pins with jumper blocks.4.CS/SL/MA pins

These pins are used to set the drive to either a master or slave device.

5.IDE connector

This connector is for a 40-pin IDE cable to connect the drive to the IDE interface on the motherboard.

6.Power connector

This DC connector is for a 4-pin power cable from the system power supply.

ASUS CRW-2410S User’s Manual

13