Setting the Jumper Terminals
Configure the the jumpers to set the device to master or slave mode before physically installing it to your computer chassis. Use jumper blocks to short the pins to your desired setting.
CAUTION: Make sure to correctly place the jumper blocks over the pins. Failure to do so may cause irreparable damage to the drive!
Jumper Terminals
Master Mode
Cover the two pins below the label MA to set the
Slave Mode
Cover the two pins below the label SL to set the
If your computer supports four IDE devices, this setting sets your
Cable Select Mode
Cover the two pins below the label CS if your computer supports a Cable Select (CSEL) signal. You need an exclusive interface cable for this setting. Refer to your computer manual for details.
ASUS | 15 |