Asus CRW-4012A Rear Panel, This connector is for a digital signal output cable, This connector is for an analog signal output cable, NOTE:, 4.IDE connector, 5.Power connector

Rear Panel

1 2 3 4 5

1.Digital audio connectorThis connector is for a digital signal output cable.2.Analog audio connectorThis connector is for an analog signal output cable.3.Jumper terminals

These pins allow you to select either Master, Slave, or Cable Select mode for the CD-ROM device.

4.IDE connector

This connector is for a 40-pin IDE cable to connect the drive to the IDE interface on the motherboard.

5.Power connectorThis DC connector is for a 4-pin power cable from the system power supply.

NOTE: The jumper pins on the leftmost part of the rear panel are factory test pins. DO NOT cover these pins with jumper blocks.

CRW-4012A User’s Manual 15