Asus E2234 P5NSLI ATX Power Connectors, P5NSLI Chassis Intrusion Connectors, 8. Chassis intrusion connector (4-1pin CHASSIS)

8. Chassi s i ntrusi on connector (4-1 pi n CH ASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

CHASSIS

+5VSB MB Chassis Signal GND

(Default)

P5NSLI Chassis Intrusion Connectors9. ATX power connectors (24-pi n EATXPWR, 4-pi n ATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

ATX12V			EATXPWR
GND	+12V DC	+3 Volts	Ground
GND	+12V DC	+12 Volts	+5 Volts
		+12 Volts	+5 Volts
		+5V Standby	+5 Volts
		Power OK	-5 Volts
		Ground	Ground
		+5 Volts	Ground
		Ground	Ground
		+5 Volts	PSON#
		Ground	Ground
P5NSLI ATX Power Connectors		+3 Volts	-12 Volts
		+3 Volts	+3 Volts

ASUS P5NSLI Series 1-33