PRI_IDE

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

STRIKER EXTREME

PIN 1

STRIKER EXTREME IDE connector

3.Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5, SATA6)

These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.

If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID

1, RAID 0+1, RAID 5, or JBOD configuration with the onboard NVIDIA®

MediaShield™ RAID controller.

The RAID function of these connectors is set to [Disabled] by default. If you intend to create a Serial ATA RAID set using these connectors, enable the RAID Enabled item under the Serial ATA Configuration sub-menu in the BIOS. See section “4.5.3 Onboard Device Configuration” for details.

SATA1

SATA3

SATA5

GND GND

GND GND

GND GND

RSATA GND

RSATA

RSATA GND

RSATA

RSATA GND

RSATA

_ RSATA

_ RSATA

_ RSATA

_ RSATA

_ RSATA

_ RSATA

TXN1 TXP1

RXN1 RXP1

TXN3 TXP3

RXN3 RXP3

TXN5 TXP5

RXN5 RXP5

SATA2

SATA4

SATA6

STRIKER EXTREME

 

 

 

 

 

GND GND

GND GND

GND GND

RSATA GND

RSATA

RSATA

GND RSATA

RSATA

GND RSATA

_ RSATA

_ RSATA

RSATA _

RSATA _

RSATA _

RSATA _

TXN2 TXP2

RXN2 RXP2

TXN4 TXP4

RXN4 RXP4

TXN6 TXP6

RXN6 RXP6

STRIKER EXTREME SATA connectors

 

 

 

 

These connectors support Native Command Queuing (NCQ), Power Management (PM) Implementation Algorithm, Hot Swap and smart setup.

ASUS Striker Extreme

2-27