3.Intel® H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~4)

These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via Serial ATA 3.0 Gb/s signal cables.

 

SATA3G_2

SATA3G_1

 

GND

GND

 

RSATA_RXP2 RSATA_TXP1

 

RSATA_RXN2

RSATA_TXN1

 

GND

GND

 

RSATA_TXN2 RSATA_RXN1

 

RSATA_TXP2

RSATA_RXP1

 

GND

GND

 

SATA3G_4

SATA3G_3

H61M-K

GND

GND

 

 

RSATA_RXP4 RSATA_TXP3

 

RSATA_RXN4

RSATA_TXN3

 

GND

GND

 

RSATA_TXN4 RSATA_RXN3

 

RSATA_TXP4

RSATA_RXP3

 

GND

GND

H61M-K Intel® SATA 3.0Gb/s connectors

•You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives.

•Due to H61 Chipset limitation, AHCI Mode only works on Windows® Vista / Windows® 7. Please use IDE Mode on Windows® XP.

•To configure the SATA type in BIOS, click Advanced Mode > Advanced tab > SATA

Configuration > SATA Mode Selection. See section 2.5.3 SATA Configuration for details.

•When using hot-plug and NCQ on Windows® Vista / Windows® 7, set the SATA Mode Selection item in the BIOS to [AHCI]. See section 2.5.3 SATA Configuration for details.

4.USB device wake-up (3-pin PS2_USBPW1~4; USBPW5~8)

Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh, power supply in reduced power mode).

PS2_USBPW1-4

1

2

2

3

 

 

 

 

 

+5V +5VSB (Default)

USBPW5-8

H61M-K

1

2

2

3

 

 

 

 

 

+5V +5VSB (Default)

H61M-K USB Device Wake Up

•The USB device wake-up feature requires a power supply that can provide 500mA on the +5VSB lead for each USB port; otherwise, the system would not power up.

•The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

ASUS H61M-K

1-27