8.Front panel audio connector (10-1 pin FP_AUDIO)

This is an interface for the front panel cable that allows convenient connection and control of audio devices.

Be default, the pins labeled LINE OUT_R/BLINE_OUT_R and the pins

LINE OUT_L/BLINE_OUT_L are shorted with jumper caps. Remove the caps only when you are connecting the front panel audio cable.

AGND +5VA BLINE OUT R

BLINE OUT L

FP_AUDIO

Line out_L

NC

Line out_R

MICPWR

MIC2

K8N-E

K8N-E Front panel audio connector

9.Chassis intrusion connector (4-1 pin CHASSIS)

This lead is for a chassis designed with intrusion detection feature. This requires an external detection mechanism such as a chassis intrusion sensor or microswitch. When you remove any chassis component, the sensor triggers and sends a high-level signal to this lead to record a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. If you wish to use the chassis intrusion detection feature, remove the jumper cap from the pins.

CHASSIS

+5VSB MB

Chassis Signal GND

K8N-E

(Default)

K8N-E Chassis intrusion connector

1-22

Chapter 1: Product introduction