
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your devices.
| Drive jumper setting | Mode of device(s) | Cable connector | |
Single device | - | Black | ||
| Master | Black | ||
Two devices | Slave | Gray | ||
| ||||
Master | Master | Black or gray | ||
| ||||
| Slave | Slave | ||
|
|
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.
• If any device jumper is set as
• Use the
This connector allows you to receive stereo audio input from sound sources such as a
Chapter 1: Product introduction |