2.10Installing a floppy disk drive

The V-Series M2NC61P system comes with one 3.25-inch drive bay for a floppy disk drive.

To install a floppy disk drive:

1.Remove the drive slot metal plate cover.

remove the metal plate cover and install the card reader module here

2.Carefully insert the floppy disk drive into the floppy drive bay until the screw holes align with the holes on the bay.

3.Secure the floppy disk drive with two screws on both sides.

3

3 2

4.Connect the floppy disk drive signal cable to the signal connector at the back of the drive.

Power cable

Floppy ribbon cable

5.Connect the other end of the signal cable to the floppy disk drive connector on the motherboard. See page 4-5 for the location of the floppy disk drive connector.

6.Connect a 4-pin power cable from the power supply unit to the power connector at the back of the floppy disk drive.

ASUS V-Series M2NC61P

2-21