Asus M2NPV-MX manual IDE connectors 40-1 pin Priide 40-1 pin Secide

3 . IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s). There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s).

	Drive jumper	M o d e	C a b l e
	setting	of device(s)	connector
Single device	Cable-Select or Master	-	Black
Two devices	Cable-Select	Master	Black
		Slave	Gray
	Master	Master	Black or gray
	Slave	Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting.

M2NPV-MX

PRI IDE

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

SEC_IDE

M2NPV-MX IDE connectors

PIN 1

ASUS M2NPV-MX 1 - 27