Asus M2S-X manual 39

7. Chassi s i ntrusi on connector (4-1 pi n CH ASSI S)

This lead is for a chassis designed with intrusion detection feature. This requires an external detection mechanism such as a chassis intrusion sensor or microswitch. When you remove any chassis component, the sensor triggers and sends a high-level signal to this lead to record a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. If you wish to use the chassis intrusion detection feature, remove the jumper cap from the pins.

	+5VSB MB	Chassis Signal GND
M2S-X

CHASSIS (Default)

M2S-X Chassis Intrusion Connector

8. Seri al ATA connectors (7-pi n SATA1, SATA2)

These next generation connectors support the thin Serial ATA cables for primary internal storage devices. The current Serial ATA interface allows up to 150 MB/s data transfer rate, faster than the standard parallel ATA with 133MB/s (Ultra ATA/133).

	SATA2					SATA1
M2S-X
			TXN2 RSATA TXP2 RSATA RXP2 RSATA RXN2 RSATA					TXN1 RSATA TXP1 RSATA RXP1 RSATA RXN1 RSATA
		GND		GND	GND		GND		GND	GND

M2S-X SATA Connectors

ASUS M2S-X 1-27