DMA Mode [ Auto]

Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5]

SMART Moni tori ng [ Auto]

Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration options: [Auto] [Disabled] [Enabled]

32Bi t Data Transfer [ Di sabl ed]

Enables or disables 32-bit data transfer.

Configuration options: [Disabled] [Enabled]

2.3.6 I DE Confi gurati on

The items in this menu allow you to set or change the configurations for the IDE devices installed in the system. Select an item then press <Enter> if you wish to configure the item.

IDE Configuration

 

Parallel ATA IDE Controller

[Both]

Hard Disk Write Protect

[Disabled]

IDE Detect Time Out (Sec)

[35]

Parall el ATA I DE Controll er [ Both]

Disables or allows selection of the IDE controller. Sets to Primary to enable the primary IDE controller only. Sets to Secondary to enable the secondary IDE controller only. Sets to Both to enable both the primary and secondary IDE controllers. Configuration options: [Disabled] [Primary] [Secondary] [Both]

H ard Di sk Wri te Protect [ Di sabl ed]

Disables or enables the devices write protection. This will be effective only when the device is accessed through BIOS. Configuration options: [Disabled] [Enabled]

I DE Detect Ti me Out [ 35]

Selects the time out value for detecting ATA/ATAPI devices. Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]

2-18

Chapter 2: BIOS Setup