2. I DE connectors (40-1 pi n PRI _I DE, SEC_I DE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s). There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device(s).

 

 

Drive jumper

Mode

Cable

 

 

setting

of device(s)

connector

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

 

 

 

Slave

Gray

 

 

Master

Master

Black or gray

 

 

Slave

Slave

 

 

 

 

 

 

 

 

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device jumpers have the same setting.

M2V-TVM

M2V-TVM IDE connectors

PRI IDE

SEC IDE

 

 

 

 

 

 

NOTE:Orient the red markings

 

 

 

 

 

 

(usually zigzag) on the IDE

 

 

 

 

 

 

ribbon cable to PIN1.

 

 

PIN1

 

 

 

PIN1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1-22

Chapter 1: Product introduction