Asus M5A99X EVO R2.0 93

SATA Port1–Port4 [AHCI]

Allows you to set the SATA configuration.
[IDE]	Set to [IDE] when you want to use the Serial ATA hard disk drives as
	Parallel ATA physical storage devices.
[RAID]	Set to [RAID] when you want to create a RAID configuration from the
	SATA hard disk drives.
[AHCI]	Set to [AHCI] when you want the SATA hard disk drives to use the
	AHCI (Advanced Host Controller Interface). The AHCI allows the
	onboard storage driver to enable advanced Serial ATA features that
	increases storage performance on random workloads by allowing the
	drive to internally optimize the order of commands.

SATA Port5–Port6 [��AHCI]

Setting this item to [IDE] instead of [RAID] or [AHCI] allows the system to recognize the optical drives connected to the SATA connector 5 or 6 when installing Windows OS.

• When the SATA Port1–Port 4 and the SATA Port5–Port6items are set to [AHCI], the information of the SATA connectors 1–6 can be seen only under the OS environment or during POST.

•For Windows® XP OS, you have to install the AHCI driver, so that you could use the SATA connectors 1–6 in AHCI mode under the OS environment.

If you use a SATA optical drive to run the Windows OS installation disk, we strongly recommend that you install the optical drive to the SATA connector 5/6 and set them to [IDE] mode.

S.M.A.R.T Status Check [Enabled]

[Enabled]	Enables the S.M.A.R.T feature.
[Disabled]	Disables the S.M.A.R.T feature.

SATA ESP on PORT1 [Disabled]