III.INSTALLATION

11.Chassis, CPU , & PowerSupply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN) These connectors support cooling fans of 500mAMP (6 Watts) or less. Orien- tate the fans so that the heat sink fins allow airflow to go across the onboard heat sink(s) instead of the expansion slots. Depending on the fan manufacturer, the wiring and plug may be different. The red wire should be positive, while the black should be ground. Connect the fan’s plug to the board taking into consid- eration the polarity of the this connector. NOTE: The “Rotation” signal is to be used only by a specially designed fan with rotation signal.

WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

 

 

 

 

 

 

 

 

 

CPU Fan Power

 

Rotation +12V

GND

Power Supply Fan

 

 

Rotation

 

 

 

Chassis Fan Power

+12V

 

 

 

 

GND

 

 

 

 

 

 

P2E-M 12-Volt Cooling Fan Power

12.Wake On LAN Connector (3-pin WOL_CON)

These connector connects to LAN cards with a Wake On LAN output, such as the ASUS PCI-L101 (see section VI. ASUS LAN Card). The connector powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that the WAKE On LAN Power Up Control is set to Enabled (see “Power Management Setup” under IV. BIOS SOFTWARE) and that your system has an ATX power supply with at least 720mA +5V standby power.

PME

INSTALLATION

Connectors

III.

 

 

 

+5 Volt Standby

Ground

IMPORTANT: Requires an ATX power supply with at least 720mA +5-volt standby power

P2E-M Wake on LAN Connector

ASUS P2E-M User’s Manual

31