3.HARDWARE SETUP
3.2Layout Contents
Motherboard Settings1) | p. 17 AGP Bus Frequency Setting |
2)
3)
4) | JEN | p. 20 | JumperFreeTM Mode Setting (Enable/Disable) |
5) | JP20 | p. 20 | I/O Voltage Setting (3.50/3.65 Volt) |
1) | System Memory | p. 21 | System Memory Support |
2) | DIMM0,1,2,3 | p. 22 | DIMM Memory Module Support |
3) | Slot 1 | p. 23 | CPU Support |
4) | SLOT1, SLOT2 | p. 28 | |
5) | PCI1,2,3,4,5 ,6 | p. 28 | |
6) | AGP | p. 29 | Accelerated Graphics Port |
1) | PS2KBMS | p. 30 PS/2 Mouse Port Connector (6 | |
2) | PS2KBMS | p. 30 PS/2 Keyboard Port Connector | |
3) | PARALLEL | p. 31 Parallel (Printer) Port Connector | |
4) | COM1, COM2 | p. 31 Serial Port COM1 & COM2 (two | |
5) | FLOPPY | p. 31 Floppy Drive Port Connector (34 pins) | |
6) | USB | p. 32 | Universal Serial Bus Port Connectors 1 & 2 (Two |
7) | Primary/Secondary IDE | p. 32 Primary/Secondary IDE Connectors (Two | |
8) | IDELED | p. 33 IDE Device Activity LED (2 pins) | |
9) | CHA_, PWR_, CPU_FAN p. 33 | Chassis, Power Supply, CPU FanPowerConnectors (3 pins) | |
10) | IR | p. 34 | |
11) | SMB | p. 34 | SMBus Connector (3 pins) |
12) | WOL_CON | p. 35 | |
13) | WOR | p. 35 | |
14) | CHASSIS | p. 36 Chassis Intrusion Alarm Lead (3 pins) | |
15) | PWR.LED (PANEL) | p. 36 | System Power LED Lead (3 pins) |
16) | KEYLOCK (PANEL) | p. 36 | Keyboard Lock Switch Lead (2 pins) |
17) | SPEAKER (PANEL) | p. 36 System Warning Speaker Connector (4 pins) | |
18) | MSG.LED (PANEL) | p. 36 System Message LED Lead (2 pins) | |
19) | SMI (PANEL) | p. 36 System Management Interrupt Lead (2 pins) | |
20) | PWR.SW (PANEL) | p. 37 | ATX / |
21) | RESET (PANEL) | p. 37 Reset Switch Lead (2 pins) | |
22) | ATXPWR | p. 38 ATX Power Supply Connector (20 pins) | |
23) | JTPWR | p. 38 | Thermal Sensor Connector |
Layout Contents
3. H/W SETUPASUS | 15 |