10.Line out selector (two 2-pin LO_L, LO_R) (on audio models only)

By default, these jumpers are shorted (jumper caps on) to route the signal from the audio controller to the rear panel Line Out jack, making the jack available for audio out devices such as speakers or a headphone. If you connect the Intel Front Panel audio cable to the AAPANEL connector (see page 2-33 for the location), remove the caps from these jumpers to allow automatic switching of audio signal between the rear panel Line Out jack and the Intel audio cable.

P4B266-E

LO_L

BLOL

FLOL

LO_R

BLOR

FLOR

P4B266-E Internal Line Out Connectors

11.Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)

These jumpers allow you to select the speaker output for a 6-channel audio system. No audio standard exists for the three pick-up surfaces on male audio ports, so it is necessary to switch the jumpers from the default position CENTER/BASS (pins 2-3) to BASS/CENTER (pins 1-2) to re-route signals on the internal leads of the Mic port.

Install the audio driver included in the support CD to use the multi- channel audio feature. See section Ò5.3 Software information.Ó

 

 

BCS

 

1

2

2

3

BCS2

 

BCS2

 

BCS1

 

BCS1

 

P4B266-E

 

(CENTER/BASS)

(BASS/CENTER)

 

 

(Default)

 

P4B266-E Bass Center Setting

ASUS P4B266-E motherboard user guide

2-23