3.Floppy disk drive connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connecting one end to the motherboard, connect the other end to the floppy drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables with pin 5 plug).

FLOPPY

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

P4B266-E

PIN 1

P4B266-E Floppy Disk Drive Connector

4.Chassis open alarm lead (4-1 pin CHASSIS)

This lead is for a chassis designed with intrusion detection feature. This requires an external detection mechanism such as a chassis intrusion sensor or microswitch. When you remove any chassis component, the sensor triggers and sends a high-level signal to this lead to record a chassis intrusion event.

If you do not wish to use the chassis intrusion lead, place a jumper cap over the pins labeled “Chassis Signal” and “Ground” to close the circuit.

P4B266-E

CHASSIS

+5VSB MB

Chassis Signal GND

P4B266-E Chassis Alarm Lead

2-28

Chapter 2: Hardware information