Creating a Security Array with Existing Data Drive

If you would like to use an existing drive that already contains data and/or is the bootable drive in your system, make sure that the new hard drive you will use in the array has the same or larger capacity as the existing drive.

Backup all important data before creating an array. Failure to do so may cause data loss.

1. In the FastBuild™ utility main menu, press “1” to select Auto Setup.

2.Use the arrow keys to go to the field Optimize Array for and select “Security” with the space bar. The Mode field displays “Mirror”.

3.Press <Ctrl-Y> to save your selection. The following message appears:

Do you want the disk image to be duplicated to another? (Yes/No)

Y - Create and Duplicate

N - Create Only

5.Press “Y” for the Create and Duplicate option. The following window prompts you to select the source drive to use.

6.Use the arrow keys to select the source drive. The FastBuild utility will copy all the data from the source drive to the target drive.

7.Press <Ctrl-Y> to save the selection and start the duplication. The following message appears:

Start to duplicate the image...

Do you want to continue? (Yes/No)

Y - Continue N - Abort

8.Select “Y” to continue. If you select “N”, you will be returned to the main menu.

9.When the duplication process is completed, the following message appears confirming that your Security array has been created.

10.Press any key to reboot the system.

11.Install the RAID driver from the support CD that came with the motherboard package.

Depending on the operating system you are installing (or that is already installed), the RAID driver installation sequence may vary.

5-30

Chapter 5: Software support