3.2Vocal POST Messages

This motherboard includes the Winbond speech controller to support a special feature called the ASUS POST Reporter™ . This feature gives you vocal POST messages and alerts to inform you of system events and boot status. In case of a boot failure, you will hear the specific cause of the problem.

These POST messages are customizable using the Winbond Voice Editor software that came with your package. You can record your own messages to replace the default messages.

Following is a list of the default POST messages and their corresponding actions, if any.

POST MessageAction

No CPU installed

• Install an Intel Pentium 4 Processor

 

into the CPU socket.

 

 

System failed CPU test

• Check the CPU if properly installed.

 

• Call ASUS technical support for

 

assistance. See the “ASUS contact

 

information” on page x.

 

 

System failed memory test

• Install 184-pin unbuffered

 

PC2100/1600 DIMMs into the DIMM

 

sockets.

 

• Check if the DIMMs on the DIMM

 

sockets are properly installed.

 

• Make sure that your DIMMs are

 

not defective.

 

• Refer to section “2.5 System

 

memory” for instruction on installing

 

a DIMM.

 

 

System failed VGA test

• Install a PCI VGA card into one of

 

the PCI slots, or a 1.5V AGP card

 

into the AGP slot.

 

• Make sure that your VGA/AGP card

 

is not defective.

 

 

System failed due to CPU over-clocking

In JumperFree mode, check your CPU settings in BIOS and make sure you only set to the recom- mended settings. See section “4.4 Advanced menu.”

In jumper mode, refer to section “2.7 Switches and jumpers.”

3-2

Chapter 3: Powering up