CLRTC

 

1

2

2

3

P4C800-E

 

 

 

Normal

Clear CMOS

(Default)

 

 

P4C800-E Clear RTC RAM

You do not need to clear the RTC when the system hangs due to overclocking. For system failure due to overclocking, use the C.P.R. (CPU Parameter Recall) feature. Shut down and reboot the system so BIOS can automatically reset parameter settings to default values.

3.USB device wake-up (3-pin USBPW12, USBPW34, USBPW56, USBPW78)

Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh, power supply in reduced power mode).

The USBPWR12 and USBPWR34 jumpers are for the rear USB ports. The USBPWR56 and USBPWR78 jumper is for the internal USB header that you can connect to the front USB ports.

 

USBPW12

 

3

 

 

2

 

2

 

 

1

 

 

 

 

+5V

+5VSB

 

(Default)

 

 

 

1

2

2

3

 

USBPW34

 

 

 

 

+5V

+5VSB

 

(Default)

 

 

P4C800-E

1

2

2

3

 

 

USBPW78

 

 

 

 

USBPW56

 

 

 

P4C800-E USB Device Wake Up

+5V

+5VSB

(Default)

 

 

1. The USB device wake-up feature requires a power supply that can provide 500mA on the +5VSB lead for each USB port. Otherwise, the system would not power up.

2.The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

2-20

Chapter 2: Hardware information