Asus P4C800 Action, POST Message, Chapter 3: Powering up, a DIMM, not defective, No CPU installed, the DIMM sockets, is not defective, into the CPU socket

3.2Vocal POST Messages

This motherboard includes the Winbond speech controller to support a special feature called the ASUS POST Reporter™. This feature gives you vocal POST messages and alerts to inform you of system events and boot status. In case of a boot failure, you will hear the specific cause of the problem.

These POST messages are customizable using the Winbond Voice Editor software that came with your package. You can record your own messages to replace the default messages.

Following is a list of the default POST messages and their corresponding actions, if any.

POST Message		Action
No CPU installed	•	Install an Intel Pentium 4 Processor
		into the CPU socket.
System failed CPU test	•	Check the CPU if properly installed.
	• Call ASUS technical support for
		assistance. See the “ASUS contact
		information” on page x.
System failed memory test	•	Install 184-pin unbuffered
		PC3200/2700/2100 DIMMs into
		the DIMM sockets.
	•	Check if the DIMMs on the DIMM
		sockets are properly installed.
	•	Make sure that your DIMMs are
		not defective.
	•	Refer to section “2.5 System
		memory” for instruction on installing
		a DIMM.
System failed VGA test	•	Install a PCI VGA card into one of
		the PCI slots, or a +0.8V/1.5V AGP
		card into the AGP slot.
	•	Make sure that your VGA/AGP card
		is not defective.

System failed due to CPU over-clocking

•Check your CPU settings in BIOS and make sure you only set to the recommended settings.

3-2 Chapter 3: Powering up