4.USB device wake-up (3-pin USBPWR_12, USBPWR_34, USBPWR_56)

Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 sleep mode (no power to CPU, DRAM in slow refresh, power supply in reduced power mode). Both jumpers are set to pins 1-2 (+5V) by default because not all computers have the appropriate power supply to support this feature.

The USBPWR_12 and USBPWR_34 jumpers are for the rear USB ports. The USBPWR_56 jumper is for the internal USB header that you can connect to the front USB ports.

1. This feature requires a power supply that can provide at least 1A on the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the system would not power up.

2.The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

USBPWR_34

USBPWR_12

USBPWR_56

1

2

 

2

3

 

 

 

 

 

+5V +5VSB (Default)

P4GE-VM

P4GE-VM USB Device Wake Up

5.SMBus 2.0 setting (6-pin J12)

This jumper allows you to enable or disable the SMBus 2.0 support on the motherboard. When these jumpers are set to pins 2-3 (Support), you may install PCI devices that comply with SMBus 2.0 specification.

P4GE-VM

SMB2.0

 

3

2

2

1

 

Not Support

Support

(Default)

 

P4GE-VM SMBus 2.0

ASUS P4GE-VM motherboard user guide

1-15