6.Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)

These jumpers allow you to select the speaker output for a 6-channel audio system. Switch the jumpers from the BASS/CENTER (pins 1-2) position to CENTER/BASS (pins 2-3) position to re-route signals on the internal leads of the Mic port.

Use the audio driver included in the support CD to install the multi-channel audio feature.

P4GE-VM

BCS1

BCS2

1

2

2

3

 

 

 

 

 

(BASS/CENTER) (CENTER/BASS) (Default)

P4GE-VM Bass/Center Setting

1.11Connectors

This section describes and illustrates the internal connectors on the motherboard.

1.Hard disk activity LED (2-pin IDE_LED)

This connector supplies power to the hard disk activity LED. The read or write activities of any device connected to the primary or secondary IDE connector cause this LED to light up.

TIP: If the case-mounted LED does not light, try reversing the 2-pin plug.

IDE_LED

P4GE-VM

P4GE-VM HDD Activity LED

1-16

Chapter 1: Product introduction