USB Function [8 USB Ports]

Allows you to set the number of USB ports to activate. Configuration options: [Disabled] [2 USB Ports] [4 USB Ports] [6 USB Ports] [8 USB Ports]

Legacy USB Support [Auto]

Allows you to enable or disable support for legacy USB devices. Setting to Auto allows the system to detect the presence of USB devices at startup. If detected, the USB controller legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled. Configuration options: [Disabled] [Enabled] [Auto]

USB 2.0 Controller [Enabled]

Allows you to enable or disable the USB 2.0 controller. Configuration options: [Disabled] [Enabled]

USB 2.0 Controller Mode [HiSpeed]

Allows you to configure the USB 2.0 controller in HiSpeed (480 Mbps) or Full Speed (12 Mbps). Configuration options: [HiSpeed ] [Full Speed]

USB Mass Storage Device Configuration

USB Mass Storage Device Configuration

USB Mass Storage Reset Delay

[20

Sec]

No USB Mass Storage device detected

 

Device #1

N/A

 

Emulation Type

[N/A]

Device #2

N/A

 

Emulation Type

[N/A]

Device #3

N/A

 

Emulation Type

[N/A]

Device #4

N/A

 

Emulation Type

[N/A]

Device #5

N/A

 

Emulation Type

[N/A]

Device #6

N/A

 

Emulation Type

[N/A]

Number of seconds

POST waits for the USB mass storage device after that start unit command.

Select Screen

Select Item

+- Change Option

F1 General Help

F10 Save and Exit

ESC Exit

USB Mass Storage Reset Delay [20 Sec]

Allows you to select the number of seconds POST waits for the USB mass storage device after the start unit command. The message “No USB mass storage device detected” appears if none is installed in the system. Configuration options: [10 Sec ] [20 Sec] [30 Sec] [40 Sec]

4-24

Chapter 4: BIOS Setup