8.CPU and chassis fan connectors (3-pin CPU_FAN1, CHA_FAN1)

The fan connectors support cooling fans of 350mA~740mA (8.88W max.) or a total of 1A~2.22A (26.64W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Lack of sufficient air flow within the system may damage the motherboard components. These are not jumpers! DO NOT place jumper caps on the fan connectors!

CPU_FAN1

GND +12V Rotation

CHA_FAN1

Rotation +12V

GND

P4PE-X/TE

P4PE-X/TE 12-Volt Fan Connectors

9.USB header (10-1 pin USB_56)

If the USB ports on the rear panel are inadequate, a USB header is available for additional USB ports. The USB header complies with USB 2.0 specification that supports up to 480 Mbps connection speed. This speed advantage over the conventional 12 Mbps on USB 1.1 allows faster Internet connection, interactive gaming, and simultaneous running of high-speed peripherals.

You may connect an optional USB 2.0/GAME module, connect the USB cable to this header. The module has two USB 2.0 ports that support the next generation USB peripherals such as high resolution cameras, scanners, and printers.

1. The USB2.0/GAME module is purchased separately.

2. Make sure to install the USB driver before using USB devices.

P4PE-X/TE

P4PE-X/TE USB 2.0 Header

NC

GND

LP5+

LP5-

USB+5V

USB_56

1

USB+5V-LP4+GND

LP4

1-20

Chapter 1: Product introduction