Memory System

.3 SETUP H/W

3. HARDWARE SETUP

3.5.1Installing Memory

The memory module (RIMM/C-RIMM) will fit in only one orientation.

IMPORTANT: Do not touch the memory module’s connectors. Handle the module only by the edges.

Channel B RIMMB2

RIMMB1

Channel A RIMMA2

RIMMA1

RIMM Sockets

RIMM with Heat Spreader

C-RIMM

P4T

P4T 184-Pin RIMM Sockets

1.Make sure that the notch keys in the module are aligned with the small ribs inside the RIMM sockets.

MOUNTING NOTCH

RDRAM (with heat spreader)

NOTCH KEYS

CONNECTORS

(TOP VIEW)

EJECTOR

RIBS (inside socket)

2.With the ejectors in the open position (as shown), push down gently but firmly on the memory module until it snaps into place. The guides on the socket’s ejectors should go through the two mounting notches on the module and the ejectors should close. If necessary, push the ejectors inward to secure the mod- ule in place.

Removing Memory

To release a memory module, push both ejectors outward and pull the module straight up and out of the RIMM sockets.

WARNING! RIMM modules become extremely hot during operation. To reduce the risk of personal injury from hot surfaces, allow the modules to cool off before removing them.

24

ASUS P4T User’s Manual