1.10.2 Internal connectors

1.IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector supports the provided UltraATA133 IDE hard disk ribbon cable. Connect the cable’s blue connector to the primary (recommended) or secondary IDE connector, then connect the gray connector to the UltraATA133 slave device (hard disk drive) and the black connector to the UltraATA133 master device.

1. Follow the hard disk drive documentation when setting the device in master or slave mode.

2.Pin 20 on each IDE connector is removed to match the covered hole on the UltraATA cable connector. This prevents incorrect orientation when you connect the cables.

3.The hole near the blue connector on the UltraATA cable is intentional.

P4U800-X

P4U800-X IDE connectors

 

PIN 1

PRI IDE1

SEC IDE1

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

2.Floppy disk drive connector (34-1 pin FLOPPY1)

This connector supports the provided floppy drive ribbon cable. After connecting one end to the motherboard, connect the other end to the floppy drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables with pin 5 plug).

P4U800-X

FLOPPY1

PIN 1

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

P4U800-X Floppy disk drive connector

1-16

Chapter 1: Product introduction