HDD S.M.A.R.T. Capability [Disabled]

Enable this option to enable the Smart Monitoring, Analysis, and Reporting Technology (SMART) feature of this motherboard.

Configuration options: [Enabled] [Disabled]

Halt On [All Errors]

This field sets the system to halt on errors according to the system functions specified in each option. Configuration options: [All Errors] [No Errors] [All, But Keyboard] [All , But Diskette] [All, But Disk/Key]

Primary and Secondary Master/Slave

IDE Primary Master

IDE Primary Master

[Auto]

Access Mode

[Auto]

Capacity

40020 MB

Cylinder

19158

Head

16

Sector

255

Transfer Mode

UDMA 2

Select Menu

Item Specific Help

To auto-detect the HDD’s size, head...on this channel.

F1

:

Help

↑↓

:

Select

Item

-/+

:

Change

Value

F5

:

Setup Defaults

ESC

:

Exit

→←

:

Select

Menu

Enter

:

Select

Sub-menu

F10

:

Save and Exit

IDE Primary Master/Slave [Auto]; IDE Secondary Master/Slave [Auto]

Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is successful, the setup BIOS automatically fills in the correct values for the remaining fields on this sub-menu. If automatic detection fails, this may be because the hard disk drive is too old or too new. If the hard disk was already formatted on a previous system, the setup BIOS may detect incorrect parameters. In these cases, select [Manual] to manually enter the IDE hard disk drive parameters. If no drive is installed or if you are removing a drive and not replacing it, select [None]. Configuration options: [None] [Auto] [Manual]

Access Mode [Auto]

The default [Auto] allows automatic detection of an IDE hard disk drive. Select [CHS] for this item if you set the IDE Channel 0/1 Master/Slave to [Manual] to enter the Hard Disk Drive values manually.

Configuration options: [CHS] [LBA] [Large] [Auto]

2-12

Chapter 2: BIOS information