Asus manual Front panel audio connector 10-1 pin Aafp, P5GC-MX Front Panel Audio Connector

9. Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC’97 audio standard.

Azalia-compliant	Legacy AC’97-compliant
pin definition	pin definition

P5GC-MX	AGND PRESENSE# MIC2 JD	HP HD	AGND NC NC NC
	AAFP
	MIC2 L MIC2 R HP R Jack Sense HP L		MIC2 L MIC2 R Line out R NC Line out L

P5GC-MX Front Panel Audio Connector

•We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high- definition audio capability.

•By default, this connector is set to AC97 Audio. If you want to connect a High Definition front panel audio module to this connector, set the Front Panel Support Type item in the BIOS to [HD Audio].

See section “2.4.4 Onboard Device Configuration” for details.

10. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5GC-MX

CHASSIS

GND (Default) Chassis Signal

+5VSB_MB

P5GC-MX Intrusion Connector

1-30 Chapter 1: Product introduction