2.IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device.

 

Driver Jumper setting

Mode of device(s)

Cable connector

Single device

Cable-Selected or Master

-

Black

Two devices

Cable-Select

Master

Black

 

 

Slave

Gray

 

Master

Master

Black or gray

 

Slave

Slave

 

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

PRI_IDE

If any device jumper is set as “Cable-Select,” ensure that all other device jumpers have the same setting.

PIN1

P5KPL-AM SE

NOTE:Orient the red markings on the IDE ribbon cable to PIN 1.

P5KPL-AM SE IDE connector3.USB connectors (10-1 pin USB56, USB78)

These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to 480 Mbps connection speed.

USB+5V USB P8- USB P8+ GND NC

USB+5V USB P6- USB P6+ GND NC

 

USB78

 

 

USB56

 

PIN 1

_USBP7-

_USBP7+ GND

PIN 1

P5KPL-AM SE

USB+5V

USB+5V _USBP5- _USBP5+ GND

P5KPL-AM SE USB2.0 connectors

Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!

The USB module cable is purchased separately.

1-11

ASUS P5KPL-AM SE