Asus p5p43t IDE connector 40-1 pin Prieide, Drive jumper setting Mode of devices Cable connector

6.IDE connector (40-1 pin PRI_EIDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device.

	Drive jumper setting	Mode of device(s)	Cable connector
Single device	Cable-Select or Master	-	Black
	Cable-Select	Master	Black
Two devices		Slave	Gray
	Master	Master	Black or gray
	Slave	Slave

•

•

Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” ensure that all other device jumpers have the same setting.

ASUS P5P43T 1-25