11 . Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

CHASSIS

P5P800

P5P800 intrusion connector

+5VSB MB

Chassis Signal GND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(Default)

12 . Front panel audio connector (10-1 pin FP_AUDIO)

This is an interface for the front panel audio cable that allows convenient connection and control of audio devices.

By default, the pins labeled LINE_OUT_R/BLINE_OUT_R and the pins LINE_OUT_L/BLINE_OUT_L are shorted with jumper caps. Remove the caps only when you are connecting the front panel audio cable.

P5P800

AGND +5VA BLINE OUT R

BLINE OUT L

FP_AUDIO

Line out_L

NC

Line out_R

MICPWR

MIC2

P5P800 Front Panel Audio Connector

2 - 32

Chapter 2: Hardware information