Front Panel Type [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or high- definition audio depending on the audio standard that the front panel audio module supports.
[HD] | Sets the front panel audio connector (AAFP) mode to high definition audio. |
[AC97] | Sets the front panel audio connector (AAFP) mode to legacy AC’97 |
Realtek LAN Controller [Enabled]
[Enabled] | Enables the Realtek LAN controller. |
[Disabled] | Disables the controller. |
Realtek PXE OPROM [Disabled]
This item appears only when you set the previous item to [Enabled] and allows you to enable or disable the PXE OptionRom of the Realtek LAN controller. Configuration options: [Enabled] [Disabled]
Serial Port Configuration
The
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM). Configuration options: [Enabled] [Disabled]
Change Settings [IO=3F8h; IRQ=4]
This item appears only when you set the previous item to [Enabled] and allows you to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
Parallel Port Configuration
The
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT/LPTE).
Configuration options: [Enabled] [Disabled]
The following two items appear only when you set the previous item to [Enabled].
Change Settings [Auto]
Allows you to select an optimal setting for Super I/O devices. Configuration options: [Auto] [IO=378h; IRQ=5;] [IO=378h; IRQ=5,6,7,9,10,11,12;] [IO=278h; IRQ=5,6,7,9,10,11,12;] [IO=3BCh; IRQ=5,6,7,9,10,11,12;]
Device Mode [STD Printer Mode]
Allows you to select the Printer Port mode. Configuration options: [STD Printer Mode] [SPP Mode]
2.5.8APM
Restore AC Power Loss [Power Off]
[Power On] | The system goes into on state after an AC power loss. |
[Power Off] | The system goes into off state after an AC power loss. |
[Last State] | The system goes into either off or on state, whatever the system state was |
| before the AC power loss. |
Chapter 2: BIOS information |