2.Intel® H77 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1~2 [gray])

These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables.

If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10 configuration with the Intel® Rapid Storage Technology through the onboard Intel® H77 chipset.

SATA6G_2

SATA6G_1

P8H77-M

 

GND RSATA TXP2 RSATA TXN2 GND RSATA RXN2 RSATA RXP2 GND

GND RSATA TXP1 RSATA TXN1 GND RSATA RXN1 RSATA RXP1 GND

P8H77-M Intel® SATA 6.0Gb/s connectors

•These connectors are set to [AHCI] by default. If you intend to create a Serial ATA RAID set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID]. Refer to section 3.5.3 SATA Configuration for details.

•Before creating a RAID set, refer to section 4.4 RAID configurations or the manual bundled in the motherboard support DVD.

•When using NCQ, set the SATA Mode Selection in the BIOS to [AHCI]. Refer to section

3.5.3 SATA Configuration for details.

•You must install Windows® XP Service Pack 3 or later versions before using Serial ATA hard disk drives. The Serial ATA RAID feature is available only if you are using

Windows® XP SP3 or later versions.

1-30

Chapter 1: Product introduction