2.Intel® Z77 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1/2 [gray])

These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables.

If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10 configuration with the Intel® Rapid Storage Technology through the onboard Intel® Z77 chipset.

P8Z77-V LX2

SATA6G_2

SATA6G_1

GND RSATA RXP2 RSATA RXN2 GND RSATA TXN2 RSATA TXP2 GND

GND RSATA RXP1 RSATA RXN1 GND RSATA TXN1 RSATA TXP1 GND

P8Z77-V LX2 SATA 6.0Gb/s connectors

These connectors are set to [AHCI Mode] by default. If you intend to create a Serial ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID

Mode]. Refer to section 3.5.3 SATA Configuration for details.

Before creating a RAID set, refer to Chapter 5 RAID Support or the manual bundled in the motherboard support DVD.

When using NCQ, set the SATA Mode in the BIOS to [AHCI Mode]. Refer to section

3.5.3 SATA Configuration for details.

You must install Windows® XP Service Pack 3 or later versions before using Serial ATA hard disk drives. The Serial ATA RAID feature is available only if you are using Windows® XP SP3 or later versions.

1 Chapter

1-20

Chapter 1: Product introduction