5.Digital audio connector (4-1 pin SPDIF_OUT)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s). Connect the S/PDIF Out module cable to this connector, then install the module to a slot opening at the back of the system chassis.

 

SPDIF_OUT

-I DELUXE

GND

P8Z77

SPDIFOUT

 

+5V

P8Z77-I DELUXE Digital audio connector

The S/PDIF module is purchased separately.

6.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P8Z77-I DELUXE

+5VSB MB

Chassis Signal GND

CHASSIS

P8Z77-I DELUXE Chassis intrusion connector

Chapter 2

ASUS P8Z77-I DELUXE

2-23