4.Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

AGND NC SENSE1 RETUR

SENSE2 RETUR

AGND NC NC

NC

AAFP

LPORT1 RPORT1 RPORT2 SEND LPORT2 Q87M-E_SENSE

HD-audio-compliant

pin definition

PIN 1

Line out_L

NC

Line out_R

MICPWR

MIC2

Legacy AC’97

compliant definition

Q87M-E Front panel audio connector

•We recommend that you connect a high-definition front panel audio module to this

connector to avail of the motherboard’s high-definition audio capability.

•If you want to connect a high-definition front panel audio module to this connector, set the Front Panel Type item in the BIOS setup to [HD]. If you want to connect an

AC’97 front panel audio module to this connector, set the item to [AC97]. By default, this connector is set to [HD]. See section 2.6.10 Onboard Devices Configuration for details.

5.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

Q87M-E

CHASSIS

+5VSB MB

Chassis Signal GND

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Q87M-E Chassis intrusion connector

ASUS Q87M-E

1-15