Serial Port Configuration
The
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).Configuration options: [Enabled] [Disabled]
Change Settings [IO=3F8h; IRQ=4]
This item appears only when you set the Serial Port to [Enabled] and allows you to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
Serial Port 1 Configuration
The
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM) 1.Configuration options: [Enabled] [Disabled]
Change Settings [IO=2F8h; IRQ=3]
This item appears only when you set the Serial Port to [Enabled] and allows you to select the Serial Port base address. Configuration options: [IO=3F8h; IRQ=4] [IO=2F8h; IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
Parallel Port Configuration
The
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT/LPTE).
Configuration options: [Enabled] [Disabled]
The following items appear only when you set the Parallel Port Configuration item to [Enabled].
Change Settings [Auto]
Allows you to select an optimal setting for Super I/O devices. Configuration options: [Auto] [IO=378h; IRQ=5;] [IO=378h; IRQ=5,6,7,9,10,11,12;] [IO=278h; IRQ=5,6,7,9,10,11,12;] [IO=3BCh; IRQ=5,6,7,9,10,11,12;]
Device Mode [STD Printe...]
Allows you to select the Printer Port mode. Configuration options: [STD Printer Mode] [SPP Mode]
2.6.11APM
Restore AC Power Loss [Power Off]
[Power On] | The system goes into on state after an AC power loss. |
[Power Off] | The system goes into off state after an AC power loss. |
[Last State] | The system goes into either off or on state, whatever the system state was |
| before the AC power loss. |
Chapter 2: Getting started |