8.Connect the 4-pin power plug(s) to the power connector of the optical drive(s).

9A. Connect the 4-pin power plug to the power connector of the IDE hard disk drive, or the Serial ATA hard disk drive with a 4-pin power plug.

- or -

9B. For Serial ATA hard disk drive without a 4-pin power plug, connect the 15-pin SATA power adapter plug to the power connector at the back of the drive, then connect the other end (4‑pin male) to a 4-pin (female) power plug from the power supply unit.

See the Appendix for the power supply specifications.

Voltage selector

The PSU has a 115 V/230 V voltage selector switch located beside the power connector. Use this switch to select the appropriate system input voltage according to the voltage supply in your area.

NOTE. The voltage selector is set to 230 V by default.

If the voltage supply in your area is 100‑127 V, set the switch to 115 V. If the voltage supply in your area is 200‑240 V, set the switch to 230 V.

Setting the switch to 115 V in a 230 V environment will seriously damage the system!

2-20

Chapter 2: Basic installation