Asus TXP4 ASUS TXP4 User’s Manual, 16.AT Power Supply Connector (12-pinblock), 17. ATX Power Supply Connector (20-pinblock)

III.INSTALLATION

16.AT Power Supply Connector (12-pin block)

This connector connects to a standard 5-volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are together.

	+5V	RED
		RED	P9
	-5V	RED
		WHT
	GND	BLK
		BLK
		BLK
		BLK	P8
	-12V	BLU
	+12V	YLW
	+5V	RED
		ORG
	PG
	Power Connector	Power Plugs from
AT Power Connector	on Motherboard	Power Supply

Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place.

17. ATX Power Supply Connector (20-pin block)

This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that the ATX power supply can take at least 10mA load on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load.

3.3V —		—	3.3V
12.0V	—	— 3.3V
GND —		—	GND
PS-ON —		—	5.0V
GND —		—	GND
GND —		—	5.0V
GND —		—	GND
5.0V	—	—	PW-OK
5.0V	—	—	5VSB
5.0V	—	—	12.0V

ATX Power Connector

INSTALLATION	(Connectors)
III.

ASUS TXP4 User’s Manual 29