SATA(SATA5,6) and M.2 Configuration [Auto]
This item allows you to set an automatic detection between the M.2 devices and SATA devices installed on SATA ports 5 and 6.
[Auto] | The system automatically detects the connected SATA and M.2 devices |
| and set a higher priority to M.2 interface. The connected device will then |
| run at PCIe mode first than SATA mode. The SATA devices are available |
| when no M.2 devices are installed. |
[SATA] | The system assigns the priority bandwidth to SATA (SATA5.6) interface |
| with M.2 Socket 3 disabled. |
[M.2] | The system assigns the priority bandwidth to M.2 Socket 3 with SATA |
| (SATA5.6) interface disabled. |
SATA Mode Selection [AHCI]
Allows you to set the SATA configuration.
[Disabled] | Disables the SATA function. |
[IDE] | Set to [IDE] when you want to use the Serial ATA hard disk drives as |
| Parallel ATA physical storage devices. |
[AHCI] | Set to [AHCI] when you want the SATA hard disk drives to use the AHCI |
| (Advanced Host Controller Interface). The AHCI allows the onboard storage |
| driver to enable advanced Serial ATA features that increases storage |
| performance on random workloads by allowing the drive to internally |
| optimize the order of commands. |
[RAID] | Set to [RAID Mode] when you want to create a RAID configuration from the |
| SATA hard disk drives. |
|
|
| The following item appears only when you set the SATA Mode Selection to [RAID]. |
|
|
Pcie Nand Configuration [Auto]
This item allows you to enable or disable PCIe NAND. Configuration options: [Auto] [Disabled] [Enabled]
Aggressive LPM Support [Disabled]
This item is designed for LPM (link power management) support with a better energy saving conditions. When disabled, the hot plug function of SATA ports are disabled. Configuration options: [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T.
Hot Plug [Disabled] (SATA6G_1 - SATA6G_6)
These items allow you to enable/disable SATA Hot Plug Support. Configuration options: [Disabled] [Enabled]
Chapter 2: Getting started |