The onboard Marvell SATA 6.0 Gb/s controller allows you to create a RAID 0, RAID 1 or RAID 10 array using two SATA hard disk drives. Refer to Chapter 2 of your system user manual for the exact location of the Marvell SATA 6.0 Gb/s connector.
To enter the Marvell utility, press <Ctrl> + <M> during POST.
All exisiting data on the hard disk drives will be erased when creating or deleting a RAID array. Ensure that you have back up all your data in your hard disk drives before making any change to the drive status.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Topology | Information |
|
|
|
|
| |
HBA 0: Marvell 0 | Vendor ID | : | 1B4B |
├ Virtual Disks | Device ID | : | 9130 |
└ Free Physical Disks | Revision ID | : | B1 |
├ PD 0: ST3160812AS | BIOS Version | : | 1.0.0.1028 |
└ PD 8: ST3160812AS | Firmware Version: | 2.2.0.1105 | |
| PCIe Speed Rate : | 5.0Gbps | |
| Configure SATA as: | AHCI Mode | |
Help | ▶ |
| ▶ |
|
|
| |
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
5.5.1Create a RAID Array
1.Move the selection bar to HBA 0: Marvell 0 and press <Enter>.
2.Select Configuration Wizard and press <Enter>.
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
|
|
|
| ||
HBA 0: Marvell 0 | Port ID | : | 0 | ||
| ├ Virtual Disks | PD ID | : | 0 | |
| └ Free Physical Disks | Type | : | SATA PD | |
* ├ PD 0: ST3160812AS | Status | : | Unconfigured | ||
| └ PD 8: ST3160812AS | Size | : | 152626MB | |
|
| Feature Support | : | MCQ 3G 48Bits | |
|
| Current Speed | : | 3G | |
|
| Model | : | ST3160812AS | |
|
| Serial | : | 9LS0F4HL | |
|
| FW Version | : | 3.AAE | |
| Help | ▶ |
| ▶ | |
|
|
|
|
| |
Use space bar to select the free disks to be used in the array.
ENTER: Operation SPACE: Select F10: Exit/Save ESC: Return
3.Press <Space> to select the hard drives to be included in the RAID array. An asterisk (*) appears in front of the selected hard drive. After selecting all the drives needed for the RAID array, press <Enter> to continue.
ASUS |