7
Getting Started
6
Getting Started
Battery installation & charging

After installation, place the handset in the base and allow the battery to charge for 12

hours before use. You can keep the battery charged by returning the handset to the base

after each use. When battery power is fully depleted, a full recharge takes about 8 hours.

Charging lightwill be illuminated
while battery is charging.
Telephone base installation

Install the telephone base as shown below. Choose a location away from electronic

equipment, such as personal computers, television sets or microwave ovens. Avoid

excessive heat, cold, dust or moisture.

NOTE:Use only the power
cord supplied with this product.
If you need a replacement, call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.
Rotate antenna
to fully upright
position
Plug power cord
transformer into
electrical outlet
Plug long line cord
into telephone jack
Place handset in base to charge for 12 hours
before first use.
Plug in battery here
Low battery indicator
Return handset to base to recharge
when this symbol appears. (Handset
will beep when battery is low.)

NEW 00 OLD 27

0 8/12 10:06 AM
Press coin into slot on
base of handset to
release latch, then
remove cover
To replace cover:
1Insert tabs at top of
cover into slots on base
2Align tab at bottom of
cover with slot in base,
then press to click in
place