AT&T 145 user manual TABLE/DESK Installation

INSTALLATION

TABLE/DESK INSTALLATION

This telephone includes a 7-foot line cord with a modular plug on each end. You’ll use this cord to connect the telephone to a modular jack.

1.Connect line cord to telephone

Plug the long line cord into the jack on the underside of the telephone base. Then feed the line cord through the channel provided so the telephone sits flat on your table or desk during use.

2.Set Dial Mode switch

This product comes set in the TONE mode. Make sure you choose the correct dialing method (TONE/PULSE); touch tone dialing will not work if you have dial pulse service.

3.Connect handset to base

Plug one end of the coiled cord into the handset, and the other end into the telephone base. Then hang up.

4.Connect line cord to modular jack

Plug the free end of the line cord into a modular jack. Make sure it snaps firmly in place.

5.Check for dial tone

Lift the handset and listen for a dial tone. If you can’t hear a dial tone, refer to “In Case of Difficulty” and try to correct the problem.

TO DISCONNECT the telephone, squeeze the clip on the modular plug and pull it out of the jack.

2