User’s Manual for the
Two-Line Speakerphone 902
Fold open this manual for information about this telephone’s installation and operation.
Please read Part 1 — Important Product
Information, included in this package.
Part 2
© 1998 Philips Consumer Communications, L.P. All rights reserved. Printed in Mexico. 848236212 Issue 1AT&T
IN CASE OF DIFFICULTY
•Try calling the number you want
to enter into memor y. When the
call is ended, press 
,
and a memory button.
•If someone lifts an extension phone while you are storing num- bers in memory, programming might be interrupted. Make sure all extensions are on hook while storing numbers in memory.
•You might not hear the confirma- tion beep if the RECEIVER (handset) volume is set too low, or if you are in a noisy location.
•If the number is more than 24 digits long, make sure you follow the directions for “Dialing Long Numbers.”
•Do not put the phone on Hold while storing numbers.
Problems With Line Status Lights
•Make sure all plugs are connected properly. Inspect the line cord connections at the modular jack and at the telephone . Also inspect the coiled handset cord connections at both ends.
•Try replacing old batteries. See “Batteries” in the Installation section.
•Make sure the batteries are correctly installed, and that the battery contact surfaces and battery case are clean.
•If only one telephone line is connected, make sure that only the batteries for that line (as labeled on the battery compartment) are installed.
Telephone Does Not Ring
•Make sure the RINGER switch is set in the LO or HI position.
•If there are several other telephones on the same line, try disconnecting some of the other telephones. Having too many telephones connected can also create problems such as low ringer volume, or impaired sound quality during calls.
Other Problems
Make sure you have followed all the instructions in this booklet. If you continue to have problems, call
1 800
