INSTALLATION

NOTE: This telephone requires a

2-line modular jack or two separate one-line modular jacks to use this unit as a two-line phone .

NOTE: To use both lines of a two- line telephone, your local telephone company must provide two telephone numbers.

Batteries

Before using the telephone, you should install AA batteries (not

included). If you are connecting only Line 1 or only Line 2, use two batteries, as indicated on the bottom of the phone. If you are connecting both lines, use four batteries.

You can use the phone without batteries to make and receive calls, but it requires batteries to power the Line Status lights.

If you have wall-mounted the telephone, follow these directions:

1Remove the telephone from the wall.

2Turn the telephone upside down.

3Remove the base by pressing the tabs located on the top of the base.

4Press down on tab on batter y door located between arrows on battery door (Figure 2A). Swing door open and insert new batteries (Figure 2B).

5Close the battery door.

CAUTION: Always unplug the line cord before installing new AA batteries.

 

Line Status

 

Lights

 

Line selection

Programs a number

Conferences

in memory

both lines

Programs a pause

 

in memory

 

Access Call Waiting

 

or other services

 

Handset

 

Temporary

 

Tone

 

Accesses memory dialing numbers

Directory Card/Cover

Line 2 Ringer Volume

Line 1 Ringer Volume

Puts a call on hold

Mutes a call

Redials last call made, or starts Auto Redial

Speaker/Handset Volume

 

Turn speaker on or off

Figure 1

 

 

Press down on tab to

 

open battery door

BATTERY DOOR CLOSED, BASE OFF

Figure 2A

BATTERY DOOR OPEN, BASE OFF

Insert 2

AAbatteries for Line 2

Insert 2

 

 

AA batteries

 

 

for Line 1

Figure 2B

Figure 3

 

Page 2
Image 2
AT&T 902 user manual Installation, Batteries