AT&T E5908 user manual Outgoing announcements, To play your outgoing announcement

begin playback. Press DELETE your announcement.

PLAY/STOP to

16

Elapsed	Press to stop
recording time	recording.
(seconds).

1. ANNC

“Announcement. Press PLAY or press RECORD.”

Answering System Operation

Outgoing announcements

Outgoing announcements are the messages callers hear when calls are answered by the answering system.

The telephone is pre-programmed with an announce- ment. If the telephone is set up to record messages, it answers calls with “Hello. Please leave a message after the tone.” You can use this announcement, or replace it with a recording of your own voice.

NOTE: Press ANNC to exit the announcement programming.

2. (Play/Stop)

(Plays announcement previously recorded).

- OR -

3. RECORD

“Record after the tone. Press STOP when you are done.”

4. Speak into microphone.

Microphone

5. (Play/Stop)

(Announcement is played back).

6. ANNC

to exit announcement programming.

To play your outgoing announcement

Press ANNC until you hear "Announcement. Press PLAY or press RECORD." Then press PLAY/STOP. You will hear the outgoing announcement.

To record your outgoing announcement

Press ANNC until you hear "Announcement. Press PLAY or press RECORD." Then press RECORD and begin speaking after you hear "Record after the tone. Press STOP when you are done." Speak fac- ing the telephone base from about nine inches away. Press PLAY/STOP when you are done. Your recorded announcement will be played back.

Elapsed time (in seconds) will be shown in the message window when recording. You can record an announce- ment up to 90 seconds long. Announcements shorter than three seconds long will not be recorded.

To delete your outgoing announcement

Press ANNC until you hear “Announcement. Press PLAY or press RECORD.” Then press

during playback to delete

When your announcement is deleted, calls will be answered with the pre-programmed announcement described above.

38